| ? |  20 seconds per minute Size: 5142K |
CF-T1 is turned over. A battery is removed and three kinds of plus screws are removed by plus of a precision driver. with an the mothod under a right-hand side palm rest cover toward the back was omitted on the movie, it also removes this Fixation of the vertical chassis of a main part and fixation with a main part and a keyboard are unfixed by this. |
| ? |  45 seconds Size: 2876K |
A keyboard is lifted upwards from the bottom
(function key side), and it slides to a liquid crystal side and removes. The
keyboard is connected through the connector with the mother board and the flat
cable turned to 90 degrees. Since it is inserted into the hole where a chassis
is oblong, it makes and it is, please take out a flat cable carefully. If a
connector fits a driver over the dent of minus for the central part and it is
slowly turned to it by the half with a minus precision driver, a white connector
will separate from it. Please extract a flat cable, if it そ. If it has a digital
camera, please photo the surroundings of this flat cable in advance. And if a
keyboard is removed, please become, as soon as you carry out marking of the
place which takes a photograph also about a chassis and where the black screw is
stuck, carry out, and distinguish from the same hole. The rest should all remove a black screw. The に which he does not forget since a screw exists in right and left under a palm rest cover especially. |
| ? |  58 seconds Size: 4321K |
An angle is changed and it becomes the photography
from the right rear. Although an up chassis is removed, since it is connected
with WheelPad, the handicap NIKESHON board, and the white flat cable, please
remove the black stop implement made of a plastic by the side of a board with
the precision driver of minus. Although the speaker and mother board of an upper
left part are connected by the back, work is possible for the time being tie.
Moreover, although the hard disk and the main part are being too fixed with the
curved flat cable, please also remove this from a main part side using the
precision driver of minus. From HDD being wrapped in the cover for opposite
shocking, please take out the rest and pull out the opposite socket of the flat
cable stuck in the pin portion of No. 1 to No. 44. Then, HDD separates.
An assembly becomes reverse [ this procedure ]. |